- Direct replacement Magura MT7 disc brake lever!
- Supplied as a complete lever, including BAT adjuster dial, reach adjuster dial and M9 shroud nut and olive.
- ONLY compatible with Magura MT-series disc brakes.
- Flip-flop design means it's possible to use on either side of your bars, as a front or rear lever.
- Available in black only.
- Weight: 70.9g
To correctly fit the lever to the handlebar, the bolt with the arrows pointing towards it must be gently tightened first until the gap is closed, then the other bolt should be nipped down. Do NOT tighten this bolt right down, normally there will be a gap of around 2-3mm when the lever is tight on the bars. Over-tightening the bolts or not following this procedure is likely to crack the lever clamp and this is not covered under warranty.