£1.50
In stock
£699.00
Sold out
Sold out
Technical InfoNew to trials? Then check out our product video guides for useful tips and technical advice
FacebookFollow us on Facebook for exclusive deals, promo codes and offers
Need some help?Have a question? No problem, call us on 01772 32 33 33 or get in touch via our contact page.
TartyBikes Ltd, Units 3-4, Club Street, Bamber Bridge, Preston, PR5 6FN
All prices listed are inclusive of sales tax at the correct rate for your country
Web Design & Development by Cox Web Design, Loughborough
Are 9mm ones able to fit on the HOPE PRO 2 EVO front hubs too?
Posted by Ryan on 26/11/2011
Reply from TartyBikes on 28/11/2011
Hi Ryan - They should work fine. The inner diameter of the bearings are the same from the Evo to the 'standard' hub. Thanks, Mark
Hi, I'm still unclear as to whether the conversion for a bolt axle will fit. You talk about the inner diameter of the bearing being 20mm but it the listing doesn't state what axle the conversion is compatible with. 9mm, 10mm? Thanks.
Posted by Rich on 30/03/2012
Reply from TartyBikes on 02/04/2012
Hi Rich - The 20mm bolt through version is ONLY suitable for use with 20mm bolt through axles and forks. The 9mm QR version will only work with a suitable QR. If required, we acn special order the other sizes Hope make (e.g. 15mm, suitable for use with 15mm through axles/forks). Thanks, Mark
Are these threaded inside to allow a bolt rather than quick release? thanks
Posted by james on 10/10/2014
Reply from TartyBikes on 13/10/2014
Hi James - thanks for your question. These cannot be used with bolts and are exclusively for use with skewers. Thanks, Flipp.
Hi, I have as front hub a bulb (Hope Pro2) with QR and want to put bolts as the rear one. What I have to do? Change axle/caps? which one. Thanks a lot for your help. Cheers.
Posted by Andrea on 17/01/2015
Reply from TartyBikes on 19/01/2015
Hi Andrea - thanks for your question. Unfortunately there is no option for using bolts in the front hubs as with the rears. To do that you would have to get a custom axle made. Thanks, Flipp.
Hi, I was wondering if the HOPE PRO 2 / 4 AXLE ADAPTORS would fit the hubs that are on the inspired flow and what I would need (for the arcade forks)
Posted by David on 21/11/2017
Reply from TartyBikes on 21/11/2017
Hi David - Unfortunately the Hope adaptors only fit the Hope hubs, sorry. The standard hubs on the Flow don't have a conversion kit, so you would need to buy a complete new hub to run a 15mm through axle system. Thanks, Mark