Potential Application
Lever pivot bolt nut for Hope Mini lever (as fitted to Mono Trial brake)
Lightweight upgrade bolts such as these should always be used with care, we cannot accept responsibility for any damage caused by incorrect installation or misuse.
Based on 2 customer ratings
Looks good but 'rounds off' easily..
Posted by Cai on 15/01/2011
These look lush when fitted to the bike, but they really aren't up too the job in my opinion. I've had two of these and one of these rounded off very quickly, and the threads basically fell out of the other one. Stick to steel nuts!
Reply from TartyBikes on 18/01/2011
Hi Cai - Sorry to hear you've had problems with them. Being quite small, we recommend using a good quality ring spanner on them, definitely not an adjustable. Aluminium does 'round off' more easily than steel, but with good tools this isn't a problem - in fact I've had a set of these on my bike with no problems since February 2007! For the application of holding a lever blade pivot pin in place they do not need much torque at all, especially with the nyloc system, so stripping the thread should not be an issue, especially with the threads greased as suggested in the product description. Thanks for your review!
Colourful updgrade
Posted by Dave on 30/01/2014
It's only an M5 nut, but a very colourful one at that. Made my old Hope brakes look a bit nicer anyway.
From £1.00 to £6.00
Technical InfoNew to trials? Then check out our product video guides for useful tips and technical advice
FacebookFollow us on Facebook for exclusive deals, promo codes and offers
Need some help?Have a question? No problem, call us on 01772 32 33 33 or get in touch via our contact page.
TartyBikes Ltd, Units 3-4, Club Street, Bamber Bridge, Preston, PR5 6FN
All prices listed are inclusive of sales tax at the correct rate for your country
Web Design & Development by Cox Web Design, Loughborough
On order
hey will this fit on the onza ska and are they good because one of the comments said that they stripped easily cheers
Posted by Calum Grant on 24/04/2012
Reply from TartyBikes on 25/04/2012
Hi Calum - I don't think this really fits anywhere on the Ska, unfortunately. As with all aluminium bolts/nuts, it's important to be careful when fitting them. Aluminium is softer than steel or titanium, so more care must be taken to use grease when installing them and to make sure they're not over-tightened. Thanks, Mark