Jitsie Integrated Booster and Clamps

Innovative brake clamp and booster system from Jitsie!

Cylinder washers not required.

- Super high quality product from Belgian brand Jitsie!
- Brake booster and the top halves of cylinder clamps made from a single piece of aluminium to provide maximum stiffness.
- CNC machined from high grade 7075 aluminium.
- Widened holes in the top clamps/booster unit allow for a slight range in frame sizes to be used. These can accommodate brake mounts spaced 85-90mm (Front) or 100-105mm (Rear) apart.
- 5.5mm of vertical adjustment.
- Washerless design means no rounded clips are required. Due to this, your pad will always be perfectly square with the brake mounts on your frame, so we recommend running a file over the brake mounts on your frame to ensure they are level with each other before fitting.
- Large recess in top face of the booster shaves off some weight without compromising stiffness.
- Minimum height to underside of arch of 42mm for the low version (24/26" and front) and 55mm for the high version (20" rear brakes), from the centre of the top hole.
- Supplied as standard with M5 steel bolts featuring extra-large heads and 3mm allen key fittings. The bolts require extra-large heads to cover the enlarged slots that make this item compatible with multiple frame sizes.
- Please note this booster will not fit 26" GU frames due to the small 'tail' on the end of the top tube fouling the top of the arch.
- Weight: just 71.6g! (Plus bolts 3mm allen key fitting bolts at 15.4g, or the 4mm allen key fitting bolts and washers at 22g.)

Great design needs beefing up.

Posted by Laurence

Was previously using the Magura clamps with trial tech 2bolt booster on my flexy rockman tractor frame. Switched to this hoping the one piece design would stiffen it up. When it arrived its a lot thinner than the pictures led me to believe, hence the light weight. Due to this it hasn't really made a difference to my previous set up, the strength:weight ratio is really good it's just a little too light weight for my light weight frame and needs beefing up ideally. I've never used the washerless clamps before and they're fantastic can't fault them atall, I'm not great at setting up brakes and they make it so much easier. May stick my old booster on top to get it stiff as possible.

	Black (Front brakes only, 85-90mm spacing)	$79.98
	Black 118mm (26" / 24" rear or 20" front brakes only)	$79.98
	Black 133mm (20" rear brakes only)	$79.98
	Red (Front brakes only, 90-95mm spacing)	$79.98
	Red 118mm (26" / 24" rear or 20" front brakes only)	$79.98
	Red 133mm (20" rear brakes only)	$79.98

Browse…

Recently viewed

Shopping basket

My Account